活性炭吸附氦气式回热器低温比热与流阻特性的研究

陈六彪; 孔春辉; 吴显林; 周远; 王俊杰

doi:10.1016/S1872-5805(18)60326-9

活性炭吸附氦气式回热器低温比热与流阻特性的研究

doi: 10.1016/S1872-5805(18)60326-9

陈六彪^1,2,
孔春辉^1,2,
吴显林^1,2,
周远^1,2,
王俊杰^1,2,

1.
中国科学院理化技术研究所, 低温工程学重点实验室, 北京 100190;
2.
中国科学院大学, 北京 100049

基金项目: 国家自然科学基金（51706233，51327806，51427806）.

详细信息

作者简介:
陈六彪,博士研究生.E-mail:chenliubiao@mail.ipc.ac.cn

通讯作者:
王俊杰,教授.E-mail:wangjunjie@mail.ipc.ac.cn

中图分类号: TB321
计量
- 文章访问数: 501
- HTML全文浏览量: 116
- PDF下载量: 338
- 被引次数: 0
出版历程
- 收稿日期: 2017-10-15
- 录用日期: 2018-02-11
- 修回日期: 2018-01-17
- 刊出日期: 2018-02-28

Specific heat capacities and flow resistance of an activated carbon with adsorbed helium as a regenerator material in refrigerators

1.
Chinese Academy of Sciences Key Laboratory of Cryogenics, Technical Institute of Physics and Chemistry, Beijing 100190, China;
2.
University of Chinese Academy of Sciences, Beijing 100049, China

Funds: National Science Foundation of China (51706233, 51327806, 51427806).

摘要

摘要: 在30 K以下温区，低温制冷机工质气体氦气的比热已高于目前常用的蓄冷材料，导致回热器蓄冷能力严重不足，限制了制冷机性能的提高。本文使用活性炭吸附部分工质气体氦气直接作为回热器填料的研究，是对制冷机蓄冷材料研究的一个全新探索。实验测试了15~30 K温度范围内活性炭对氦气的吸附量，并将其比热与不锈钢丝网、铅球、磁性材料Er₃Ni/HoCu₂等常规蓄冷材料进行了比较。另外，搭建了阻力测试装置，对活性炭吸附氦气式蓄冷单元以及磁性材料Er₃Ni、HoCu₂和不锈钢丝网的流动阻抗进行了实验测试。研究结果表明，活性炭吸附氦气式蓄冷单元比热在25K以下已经接近甚至高于目前已知的常规蓄冷材料，同时，其流动阻抗与磁性材料Er₃Ni的数值接近，略高于HoCu₂，但低于635目不锈钢丝网。基于比热与流阻的角度，初步验证了其作为极低温区制冷机蓄冷器的可行性。
- 活性炭 /
- 磁性材料 /
- 氦气吸附 /
- 比热 /
- 流动阻抗
Abstract: An ideal regenerator material is characterized by a high specific heat capacity and a low flow resistance, and the specific heat capacity of the working gas must be low. However, the specific heat capacity of a helium working gas is much higher than that of the general regenerator materials in the temperature range 4-30 K, which severely limits the improvement of the refrigerator performance. The helium adsorption capacity of the activated carbon was first evaluated. The heat capacity and flow resistance of the activated carbon with adsorbed helium were measured and compared with the commonly-used regenerator materials such as stainless steel wire mesh, lead, and magnetic Er₃Ni and HoCu₂. Results show that the specific heat capacity of the activated carbon with adsorbed helium are higher than those of the other materials investigated at 3.0 MPa and 16-25 K, and its flow resistance is close to that of Er₃Ni, a little bit higher than that of HoCu₂, and much less than that of the stainless steel wire mesh. These results confirm that it is feasible to use activated carbon with adsorbed helium as a regenerator material.
- Activated carbon /
- Rare-earth material /
- Adsorbed helium /
- Specific heat capacity /
- Flow resistance

HTML全文

下载: 全尺寸图片幻灯片

参考文献(14)

Chen L, Wu X, Liu X, et al. Numerical and experimental study on the characteristics of 4 K gas-coupled Stirling-type pulse tube cryocooler[J]. International Journal of Refrigeration, 2018, https://doi.org/10.1016/j.ijrefrig.2018.01.010.

Liu S, Chen L B, Wu X, et al. 10 K high frequency pulse tube cryocooler with precooling[J]. Cryogenics, 2016, 77:15-19.

Zhou Q, Chen L, Zhu X, et al. Development of a high-frequency coaxial multi-bypass pulse tube refrigerator below 14 K[J]. Cryogenics, 2015, 67:28-30.

Chen L, Zhou Q, Jin H, et al. 386 mW/20 K single-stage stirling-type pulse tube cryocooler[J]. Cryogenics, 2013, 57:195-199.

Xu B, Jin T, Li C, et al. Study on reaction characteristics of Er₃Ni hydrogenation[J]. Rare Metal Materials and Engineering, 2011, 40(1):14-17.

Jin T, Xu B, Li C, et al. Study on the hydrogen absorption capacity of magnetic regenerative material Er₃Ni[J]. Journal of Engineering Thermophysics, 2011, 32(1):6-8.

Jin T, Li C, Tang K, et al. Hydro-genation-induced variation in crystal structure and heat capacity of magnetic regenerative material Er₃Ni[J]. Cryogenics, 2011, 51:214-217.

D Lozano-Castello, M Jorda Beneyto, Cazorla-Amoros, et al. Characteristics of an activated carbon monolith for a helium adsorption compressor[J]. Carbon, 2010, 48:123-131.

Gao F, Wang Y, Li C, et al. Surface modification of activated carbon for CO₂ adsorption[J]. New Carbon Materials, 2014, 29(2):96-101.

Song T, Liao J M, Xiao J, et al. Effect of micropore and mesopore structure on CO₂ adsorption by activated carbons from biomass[J]. New Carbon Materials, 2015, 30(2):156-166.

Dundar E, Zacharia R, Chahine R, et al. Modified potential theory for modeling supercritical gas adsorption[J]. International journal of hydrogen energy, 2012, 37:9137-9147.

Tang B, Hu G, Gao H, et al. Application of graphene as filler to improve thermal transport property of epoxy resin for thermal interface materials[J]. International Journal of Heat and Mass Transfer, 2015, 85:420-429.

Inagaki Michio. Pores in carbon materials-importance of their control[J]. New Carbon Materials, 2009, 24(3):193-222.

Chen Y, Zhou L, Hong Y, et al. Preparation of high surface area activated carbon from coconut shell fibers[J]. New Carbon Materials, 2010, 25(2):151-155.

施引文献

资源附件(0)

访问统计