Effect of the pH of the preparation medium on the microstructure and electrocatalytic activity of carbon nanotubes decorated with PtSn nanoparticles for use in methanol oxidation

LI Hai-chao; CHEN Shui-xia; LI Qi-han; LIU Feng-lei

Article Contents

Article Navigation > New Carbon Mater. > 2016 > 31(3): 293-300

LI Hai-chao, CHEN Shui-xia, LI Qi-han, LIU Feng-lei. Effect of the pH of the preparation medium on the microstructure and electrocatalytic activity of carbon nanotubes decorated with PtSn nanoparticles for use in methanol oxidation. New Carbon Mater., 2016, 31(3): 293-300.

Citation:

PDF( 2709 KB)

Effect of the pH of the preparation medium on the microstructure and electrocatalytic activity of carbon nanotubes decorated with PtSn nanoparticles for use in methanol oxidation

1.
PCFM Lab, School of Chemistry and Chemical Engineering, Sun Yat-Sen University, Guangzhou 510275, China;
2.
Materials Science Institute, Sun Yat-Sen University, Guangzhou 510275, China

Funds: National Natural Science Foundation of China (50373053);Science and Technology Project of Guangdong Province (2012B091000080).

Received Date: 2016-05-07
Accepted Date: 2016-06-28
Rev Recd Date: 2016-06-05
Publish Date: 2016-06-28

Abstract

Abstract

Carbon nanotubes (CNTs) decorated with PtSn nanoparticles (PtSn/CNT) were prepared by the microwave-assisted ethylene glycol reduction method and characterized by atomic adsorption spectroscopy, X-ray diffraction and transmission electron microscopy. Results indicated that the loading efficiency of the metal catalyst, and the degree of alloying and morphology of the PtSn nanoparticles were significantly affected by the solution pH value of the metallic ions in the ethylene glycol. The required composition of the PtSn/CNT catalysts could be obtained by adjusting the pH value to about 5, which is almost the isoelectric point of the acid-treated CNTs. The size of the PtSn nanoparticles decreased with the pH value in the range 2 to 7, but they became large and agglomerated when the pH value was greater than 7. Electrocatalytic activity tests indicated that the PtSn-CNTs prepared at pH 5 had the best catalytic performance towards methanol oxidation. The improvement in catalytic activity was mainly attributed to a high loading efficiency and control of particle shape and size distribution.
- Microwave irradiation,
- Carbon nanotubes,
- PtSn catalyst,
- Methanol electro-oxidation

FullText(HTML)

References(29)

References

Eileen Hao Yu, Xu Wang, Ulrike Krewer, et al. Direct oxidation alkaline fuel cells: from materials to systems[J]. Energy Environ Sci, 2012, 5: 5668-5680.

Kamarudin M Z F, Kamarudin S K, Masdar M S, et al. Direct ethanol fuel cells[J]. Int J Hydrogen Energ, 2013, 38(22): 9438-9453.

Léger J M, Rousseau S, Coutanceau C, et al. How bimetallic electrocatalysts does work for reactions involved in fuel cells? Example of ethanol oxidation and comparison to methanol[J]. Electrochim Acta, 2005, 50(25-26): 5118-5125.

Antolini E. Catalysts for direct ethanol fuel cells[J]. J Power Sources, 2007, 170(1): 1-12.

Zheng L, Xiong L, Sun J, et al. Capping agent free synthesis of PtSn bimetallic nanoparticles with enhanced electrocatalytic activity and lifetime over methanol oxidation[J]. Catal Commun, 2008, 9(5): 624-629.

Seden Beyhan, Christophe Coutanceau. Promising anode candidates for direct ethanol fuel cell: Carbon supported PtSn-based trimetallic catalysts prepared by Bönnemann method[J]. Int J Hydrogen Energ, 2013, 38(16): 6830-6841.

Zhao S L, Yin H J, Du L, et al. Three dimensional N-doped graphene/PtRu nanoparticle hybrids as high performance anode for direct methanol fuel cells[J]. J Mater Chem A, 2014, 2: 3719-3724.

Yang C, Wang D, Hu X, et al. Preparation and characterization of multi-walled carbon nanotube (MWCNTs)-supported Pt-Ru catalyst for methanol electrooxidation[J]. J Alloys Compd, 2008, 448(1-2): 109-115.

Hsieh C T, Chou Y W, Chen W Y. Fabrication and electrochemical activity of carbon nanotubes decorated with PtRu nanoparticles in acid solution[J]. J Alloys Compd, 2008, 466(466): 233-240.

Okaya K, Yano H, Uchida H, et al. Control of particle size of Pt and Pt alloy electrocatalysts supported on carbon black by the nanocapsule method[J]. ACS Appl Mater Interfaces, 2010, 2(2): 888-895.

Nitul Kakati, Jatindranath Maiti, Seok Hee Lee, et al. Anode catalysts for direct methanol fuel cells in acidic media: Do we have any alternative for Pt or Pt-Ru?[J]. Chem Rev, 2014, 114 (24): 12397-12429.

Neto A O, Watanabe A Y, Brandalise M, et al. Preparation and characterization of Pt-Rare Earth/C electrocatalysts using an alcohol reduction process for methanol electro-oxidation[J]. J Alloys Compd, 2009, 476(1-2): 288-291.

Yin S, Shen P K, Song S, et al. Functionalization of carbon nanotubes by an effective intermittent microwave heating-assisted HF/H₂O₂ treatment for electrocatalyst support of fuel cells[J]. Electrochimica Acta, 2009, 54(27): 6954-6958.

Chen W, Jie Z, Lee J Y, et al. Microwave heated polyol synthesis of carbon nanotubes supported Pt nanoparticles for methanol electrooxidation[J]. Mater Chem Phys, 2005, 91(1): 124-129.

Ahmadi T S, Wang Z L, Green T C, et al. Shape-controlled synthesis of colloidal Platinum nanoparticles[J]. Science, 1996, 272(5270): 1924-1926.

Christina B, Chantal P, Martin C, et al. Size-selected synthesis of PtRu nano-catalysts: Reaction and size control mechanism[J]. J Am Chem Soc, 2004, 126(25): 8028-8037.

Li X, Chen W X, Zhao J, et al. Microwave polyol synthesis of Pt/CNTs catalysts: Effects of pH on particle size and electrocatalytic activity for methanol electrooxidization[J]. Carbon, 2005, 43(10): 2168-2174.

Dong H, Wang D, Sun G, et al. Assembly of metal nanoparticles on electrospun nylon 6 nanofibers by control of interfacial hydrogen-bonding interactions[J]. Chem Mater, 2008, 20(21): 6627-6632.

Xu Y, Xie X, Guo J, et al. Effects of annealing treatment and pH on preparation of citrate-stabilized PtRu/C catalyst[J]. J Power Sources, 2006, 162(1): 132-140.

Jeng K T, Chien C C, Hsu N Y, et al. Performance of direct methanol fuel cell using carbon nanotube-supported Pt-Ru anode catalyst with controlled composition[J]. J Power Sources, 2006, 160(1): 97-104.

Li H, Sun G, Lei C, et al. Comparison of different promotion effect of PtRu/C and PtSn/C electrocatalysts for ethanol electro-oxidation[J]. Electrochimica Acta, 2007, 52(24): 6622-6629.

Hui X H, Shui X C, Yuan C. Platinum nanoparticles supported on activated carbon fiber as catalyst for methanol oxidation[J]. J Power Sources, 2008, 175(175): 166-174.

Rodríguez-Reinoso F. The role of carbon materials in heterogeneous catalysis[J]. Carbon, 1998, 36(3): 159-175.

Radovic L R, Rodriguez-Reinoso F. In Chemistry and Physics of Carbon[M]. Thrower P A, E Marcel Dekker Inc, New York, 1996, 25: 243-360.

Yu R Q, Chen L W, Liu Q P, et al. Platinum deposition on carbon nanotubes via chemical modification[J]. Chem Mater, 1998, 10(3): 718-722.

Leon C A L Y, Solar J M, Calemma V, et al. Evidence for the protonation of basal plane sites on carbon[J]. Carbon, 1992, 30(5): 797-811.

Du H Y, Wang C H, Hsu H C, et al. Controlled platinum nanoparticles uniformly dispersed on nitrogen-doped carbon nanotubes for methanol oxidation[J]. Diamond Relat Mater, 2008, 17(4-5): 535-541.

Jiang L, Lian G. Modified carbon nanotubes: An effective way to selective attachment of gold nanoparticles[J]. Carbon, 2003, 41(15): 2923-2929.

Neto A O, Dias R R, Tusi M M, et al. Electro-oxidation of methanol and ethanol using PtRu/C, PtSn/C and PtSnRu/C electrocatalysts prepared by an alcohol-reduction process[J]. J Power Sources, 2007, 166(1): 87-91.

Relative Articles

Supplements(0)

Cited By

Proportional views